ip route 0.0.0.0 0.0.0.0 10.xx.10.10 - default route safety valve while we are in implementation
ip route 10.0.0.0 255.0.0.0 10.xx.10.10 - same as above
ip route 10.xx.250.0 255.255.255.0 10.xx.0.10 - ISO network unrelated
Edge BGP Config
router bgp 64BBB
network 10.40.0.0 mask 255.255.0.0
network 172.XXX.113.YYY mask 255.255.255.252
network 172.XXX.113.YYY mask 255.255.255.255
neighbor 10.xx.10.1 remote-as 65AAA
neighbor 152.XXX.63.Y remote-as 65ZZZ
neighbor 152.XXX.63.Y route-map blockzero in - provider upstream router
ip forward-protocol nd
ip route 0.0.0.0 0.0.0.0 198.XXX.255.YYY 250 - backup route from provider
ip route 10.XXX.0.0 255.255.0.0 10.XXX.10.1 - your for all site sbnets to our Core
ip bgp-community new-format
ip community-list 1 permit 65000:1
route-map blockzero deny 10
match community 1
route-map blockzero permit 20
the configurations look pretty harmless (new bgp commands should effect much at all). Is it possible the BGP keep alives are not in the correct format between the 2801 and the 3750G??? And how would this have changed?
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...