we have some strange problem on our c7200 IOS 12.2(31) with an eBGP peer.
the eBGP session begins as usuall and without any problem, all prefixes (Full BGP table) are announced to the neighbour, of course during this time the CPU goes high up to 80%. Then the both peers are in sync and traffic run as usuall, but after some minutes the CPU goes again upto 80% and the debug on the neighbour side shows that it gets again the BGP updates for all BGP prefixes from our 7200 with "rejected - duplicated" comments for every recieved prefix, it means that it gets the updates for prefixes which are allready exists in BGP table.
And it heppens every 3-5 minutes. Trully said I can't explain why our 7200 always tries to send the Full bgp table again and again.
The work-around was to configure the peer with "soft inbound", it's OK and we'd like to use it anyway , but from my opinion BGP shouldn't send Full BGP table very 5 minutes without "soft inbound" as well.
thank you for advise, on most BGP session I've removed it already.
but our problem was a bit different - I was observing th "sh ip bgp summary" on the NPE-G2 router and could see then "BGP Path" was constantly growing up to 600K, all other routers (NPE-G1 and smaller) don't have such behaviour. And of cause the processing of 600K BGP takes too much CPU time, after IOS update, "BGP Path" stays stable as on all other routers.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...