Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Strange dial-up config Is this possible

Hi,

I have a system which uses synchronous modems via a leased line for inter-site connectivity, I need to replace the leased line with a dial up link (no ADSL or ISDN available), but I can not remove one of the modems due to it being integrated into the system.

Will the following work?

Site A

The output of the fixed synchronous modem routed to one port of an analogue modem card (WIC-2AM-V2 fitted in a 2801), the second analogue modem port would then be configured as dial-up to work over POTS.

Site B

The POTS would be connected to a dial-up analogue modem (WIC-2AM-V2 fitted in a 2801), the data would then be fed out via a serial card (WIC-1T) using RS232 to the system.

Thanks

1 REPLY
Silver

Re: Strange dial-up config Is this possible

Here is the URL which will help you for the configuration for the modem support and Asynchronous device

http://www.cisco.com/en/US/docs/ios/12_0/dial/configuration/guide/dcmodem.html

88
Views
0
Helpful
1
Replies