Hai All,
One of my customer is facing a strange problem when accessing sites.Customer is running Multilink (4Mbps 2x2).When customer is opening the sites only images are not displayed in the page.Physical media dosent have any issue.Customer VPN is running fine.
customer has done the config changes "no PPP multilink fragment disable "
Have isolated the customer LAN by connecting Laptop directly to Router ... but observed the same issue
Please find the below customer end config
Please help me regarding this
XXXXX#sh run
Building configuration...
!
boot-start-marker
boot-end-marker
!
!
no aaa new-model
ip subnet-zero
!
!
!
ip name-server XXXXXXXXXXXXX
ip name-server XXXXXXXXXXXXX
no ftp-server write-enable
!
!
!
!
interface Multilink1
ip address XXXXXXXXXXXXX
ip nat outside
ppp chap hostname XXXXXXXXXXXXX
ppp multilink
ppp multilink group 1
!
interface Multilink6
no ip address
load-interval 30
ppp multilink
ppp multilink group 6
!
interface FastEthernet0/0
ip address XXXXXXXXXXXXX
ip nat inside
duplex auto
speed auto
!
interface Serial0/0
bandwidth 2048
no ip address
encapsulation ppp
no ip route-cache
load-interval 30
ppp multilink
ppp multilink group 1
!
interface FastEthernet0/1
no ip address
shutdown
duplex auto
speed auto
!
interface Serial0/1
bandwidth 2048
no ip address
encapsulation ppp
load-interval 30
ppp multilink
ppp multilink group 1
!
ip nat inside source list 1 interface Multilink1 overload
no ip classless
ip route 0.0.0.0 0.0.0.0 Multilink1
ip http server
!
access-list 1 permit XXXXXXXXXXXXX
dialer-list 1 protocol ip permit
snmp-server community public RO
snmp-server enable traps tty
snmp-server enable traps isdn call-information
snmp-server enable traps isdn layer2
snmp-server enable traps isdn chan-not-avail
snmp-server enable traps isdn ietf
!
