Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Strange message at the end of booting Cisco1841

Hello,

When we upgraded to IOS c1841-ipbasek9-mz.124-22-YB5 and reloaded the router we received following messages at the end of the boot process:

licensing flash block 0 needs to be initialized

licensing flash block 1 needs to be initialized

licensing flash block 0 needs to be initialized

licensing flash block 1 needs to be initialized

Does anyone know what this means.

Thank you in advance

Dimitri

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: Strange message at the end of booting Cisco1841

Dimitri,

      This usually happens when unused parts of the Flash are being accessed. Try these steps

1. Reload the router again.

2. If the message appears again, format the flash and reload the IOS

3 REPLIES
Bronze

Re: Strange message at the end of booting Cisco1841

Dimitri,

      This usually happens when unused parts of the Flash are being accessed. Try these steps

1. Reload the router again.

2. If the message appears again, format the flash and reload the IOS

New Member

Re: Strange message at the end of booting Cisco1841

hi Vijay,

Thank you for your reply.

When we reloaded the device the messages did not appear anymore.

So i presume this is just a notification message and cannot cause any problems?

Thanks again

Bronze

Re: Strange message at the end of booting Cisco1841

Right, it should not cause any issues

2777
Views
10
Helpful
3
Replies