I have conflicting range of IP for site A and site B. we use a NAT router in between. we passthrough traffic that doesnt require NATing.
we have a website on siteB(abc.siteb.com) that siteA has to access.
the host "abc" is NATed. when the user type http://abc on the browser, they are able to access siteB website. however, when they use http://abc.siteb.com, it fail.
we found out that the DNS server replicate all siteB.com over, and therefore when the user type abc.siteB.com, it go direct to the siteB.com zone and searches for the real address of "abc" instead of the NATed ip.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...