Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Stratacom - IGX - Questions regarding connections and trunks paths

Is there any command that will show which ports/lines are being used for a connection and/or trunk?

I?m aware that when using the command ?dspcon x.x.y.y? it will indicate the trunks being used, yet no information is displayed indicating which physical lines or ports are transversed.

1 REPLY
Silver

Re: Stratacom - IGX - Questions regarding connections and trunks

dsplnerrs checks the line alarm status and reports the number of major or minor errors and any disabled lines.Refer URL

http://www.cisco.com/en/US/products/sw/ps2346/ps99/products_tech_note09186a0080093bd7.shtml

111
Views
0
Helpful
1
Replies
CreatePlease to create content