Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Stub Question

I am trying to enter the following command on some of our remote vendor sites. Some of the sites allow me to enter the stub redistribute command and some will not. I have varying IOS versions on these routers but all of them are higher than the 12.0 when stub feature was introduced. I have researched and cannot find any documentation on where the stub redistribute command was introduced later. Is this an IOS version issue or is something else causing me not to have the mentioned feature?

router eigrp 1

redistribute static route-map static-eigrp

network 192.168.1.0

eigrp stub connected redistributed

no auto-summary

access-list 90 permit 172.16.168.13

access-list 90 permit 172.16.168.14

route-map static-eigrp permit 10

match ip address 90

3 REPLIES

Re: Stub Question

Are the stubs using receive-only statement by any chance?

Any combination of the route types can be specified on the eigrp stub statement, except receive-only, which cannot be used with any other option

HTH

Narayan

Community Member

Re: Stub Question

Nope. Just trying to issue the commands I posted. No eigrp stub receive-only statement. Below is the options I see when adding the statement.

When option is not available.

eigrp stub ?

connected Do advertise connected routes

receive-only Set IP-EIGRP as receive only neighbor

static Do advertise static routes

summary Do advertise summary routes

Option available.

eigrp stub ?

connected Do advertise connected routes

leak-map Allow dynamic prefixes based on the leak-map

receive-only Set IP-EIGRP as receive only neighbor

redistributed Do advertise redistributed routes

static Do advertise static routes

summary Do advertise summary routes

Community Member

Re: Stub Question

112
Views
0
Helpful
3
Replies
CreatePlease to create content