Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

STUN & Channelized E1

Hi all,

I need to configure a stun between 2 routers.

Both routers can ping each other and both E1s are UP on each side.

The pb is that both tunnels stay always closed ..

Any ideas ??

Thks

3 REPLIES
New Member

Re: STUN & Channelized E1

Are your end stations configured properly? Your config looks fine.

Most commonly overlooked items are:

1. mtu (did you try 4400?)

2. nrzi-encoding

3. clock rate

Hope this helps.

Hall of Fame Super Silver

Re: STUN & Channelized E1

It might be helpful if we knew what kind of device was connected to the STUN serial interfaces.

The config as posted is fairly straightforward and I do not see a problem. The suggestions about nrzi and clock rate may be very good suggestions (especially depending on what is connected on the serial interfaces).

One other thing to check is IP connectivity. Can you do an extended ping specifying the destination as the remote loopback and specifying the source as the local loopback. Is there any possibility that there are access lists filtering traffic anywhere along the path?

HTH

Rick

New Member

Re: STUN & Channelized E1

thks for ur help guys ..

1- all I know about the equipment connected is that they are from ALCATEL company and used for EDGE or GPRS connection on a cell phone network.

2-I've already done an extended ping specifiing the source and dest loopback and it works FINE. I'm not doing any ACLs on the path also.

3-I'm going to look more in depth NRZ or clock rate parameters.

thks again

149
Views
0
Helpful
3
Replies