07-28-2009 09:50 AM - edited 03-04-2019 05:34 AM
Hi
#int s0/0.1
and
#int s0/0:1
What is the different's in this above command.
it is possible to create a sum int with "." & ":" in router's and switches.?
07-28-2009 09:52 AM
The first command is subinterface .1 from serial 0/0.
The second command is the main interface from a modular router on slot 0 module 1.
I don't understand your second question.
__
Edison.
07-28-2009 02:48 PM
Hi Edison,
Are you sure about that second command? I believe that the second command using colons like "s0/0:1" is used to describe individual channel groups on an ISDN PRI (T1/E1) interface. Even on modular Cisco devices with multiple shelves and slots, the physical interface naming uses only slashes. The dot character designates subinterfaces, the colon character designates channel groups. The following URL contains slightly more information:
As to the second question - it was probably meant to ask if there is a possibility to designate multiple interfaces on a single line in a fashion similar to the "interface range" command. As far as I know, routers may support the "interface range" command but it is not usable for every interfaces and its support may vary from model to model.
Best regards,
Peter
07-28-2009 02:55 PM
channel-group - that's it. thanks for the assist.
07-28-2009 06:06 PM
Hi thank you very much for your help. :)
07-28-2009 06:10 PM
hi Peter,
Thank you very much.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide