Are you sure about that second command? I believe that the second command using colons like "s0/0:1" is used to describe individual channel groups on an ISDN PRI (T1/E1) interface. Even on modular Cisco devices with multiple shelves and slots, the physical interface naming uses only slashes. The dot character designates subinterfaces, the colon character designates channel groups. The following URL contains slightly more information:
As to the second question - it was probably meant to ask if there is a possibility to designate multiple interfaces on a single line in a fashion similar to the "interface range" command. As far as I know, routers may support the "interface range" command but it is not usable for every interfaces and its support may vary from model to model.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.