Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Sub interfaces on 1841 router

can 2 subinterfaces point to the same ip unnumbered fastethernet0/0 port on a router. Will this cause any issues? I need to do this while we change over to a new DS3 and keep our current DS3 up and running temporarily. As soon as I switch over to the new dlci, I will put the old dlci in shut on our core router.

Example:

interface Serial0/1/0.1 point-to-point

description connected to test

ip unnumbered FastEthernet0/0

no ip mroute-cache

frame-relay interface-dlci 100

!

interface Serial0/1/0.300 point-to-point

description connected to test

ip unnumbered FastEthernet0/0

no ip mroute-cache

frame-relay interface-dlci 300

1 REPLY
Hall of Fame Super Gold

Re: Sub interfaces on 1841 router

There is no problem in doing that.

Technically speaking, p-t-p serial interfaces and sub-if, do not need an IP address.

Please rate post if it helps!

116
Views
0
Helpful
1
Replies