Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Sub-interfaces

hi

let say we deal with frame-relay hub and spoke and we have sub interfaces taken in place

and we have to assign access-list/ospf priority/pim sparse/QOS/mac-address command...so am confused where to apply this

these commands ;is it on the main interfaces or in sub interfaces.

plz Declare

thanks and

with my best Rgs

ALI

Lebanon

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Sub-interfaces

Ali

You apply access list, or ospf priority, or the other parameters where the IP address is configured which is on the subinterfaces.

HTH

Rick

3 REPLIES
Hall of Fame Super Gold

Re: Sub-interfaces

Ali

You apply access list, or ospf priority, or the other parameters where the IP address is configured which is on the subinterfaces.

HTH

Rick

Community Member

Re: Sub-interfaces

thanks a lot

Hall of Fame Super Gold

Re: Sub-interfaces

Ali

I am glad that my response was helpful. Thank you for using the rating system to indicate that your questin was resolved (and thanks for the rating). It makes the forum more useful when people can read a question and can read responses which did resolve the question.

The forum is an excellent place to learn about Cisco networking. I encourage you to continue your participation in the forum.

HTH

Rick

104
Views
0
Helpful
3
Replies
CreatePlease to create content