Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

subinterface

how to create subinterface on 2800 router? what is the purpose of creating subinterface? thanks!

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: subinterface

attaching 2 documents hope it helps you

google it for Router on stick or inter vlan routing you will get some utube video also those videos will be better than these document

8 REPLIES
Silver

Re: subinterface

Suppose u want to create subinterface on your fast ethernet 0/0 port then

Config t

int f0/0.1 (instead of 0 it is 0.1 if want more 0.2,0.3etc)

you will see prompt as subinterface

then you can define ip etc

Subinterface are used for intervlan routing. So that host on vlan1 can talk to host on vlan 2.

If you are not using suninterface you need 2 fastethernet port on your router for intervlan routing.

Hall of Fame Super Gold

Re: subinterface

Oliver

Perhaps there is an aspect of the response from Vishwamurti which could be clarified. Using subinterfaces on a router FastEthernet interface configures it to do trunking and to communicate with a switch whose interface connecting to the router is configured as a trunk. Each subinterface of the router interface corresponds to a VLAN in the trunked interface from the switch.

HTH

Rick

Silver

Re: subinterface

Thanks Rick for clarifying it further.

New Member

Re: subinterface

thanks, Rick...do you know of a link for further reading?

Silver

Re: subinterface

attaching 2 documents hope it helps you

google it for Router on stick or inter vlan routing you will get some utube video also those videos will be better than these document

Silver

Re: subinterface

Re: subinterface

Oliver,

Again adding to the usage of subinterfaces. Apart from it's use in intervlan routing, sub interfaces are also used in Frame-relay networks, to divide partially meshed network into smaller fully meshed sub networks.

Point-to-Point sub interfaces are generally the preferred method in frame-relay networks.

HTH

Lejoe

Super Bronze

Re: subinterface

Subinterfaces are also often used for ATM network too.

The key concept of subinterfaces, they allow for multiple logical interfaces off one physical interface. As other posters have described, these logical interfaces would behave much a physical interfaces connected to various networks whether they are Ethernet VLANs, frame-relay or ATM virtual circuits, etc.

A couple of issues using subinterfaces, because they share a physical interface, there are sometimes configuration restrictions compared to what might be done on the physical interface, and since they share a physical interface they also share its bandwidth.

1221
Views
0
Helpful
8
Replies
CreatePlease to create content