Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Subrate DS3 configuration on a 2951 using an NM-T3/E3

Hi,

We have an old 3725 router with a HSSI card connected to a DL3100, which in turn is connected to a subrate DS3 circuit. The plan is to replace the router with a new 2951 router and a NM-T3/E3 card.

After the router was replaced, I configured the NM but the circuit remained dow/down. I'm sure it has to do with the fact that the DS3 circuit is channalized but I'm not sure how to configure this module to be channalized. Here is the configuration that I placed on the router:

                controller T3 1/0

clock source line

framing c-bit

!

interface Serial1/0

bandwidth 10240

no ip address

encapsulation frame-relay IETF

frame-relay lmi-type cisco

load-interval 30

dsu bandwidth 10240

dsu mode 0

!

interface Serial1/0.105 point-to-point

ip address 10.10.10.1 255.255.255.252

frame-relay interface-dlci 105 IETF

Any help would be appreciated.

Everyone's tags (3)
4 REPLIES
Hall of Fame Super Gold

Re: Subrate DS3 configuration on a 2951 using an NM-T3/E3

It is very unlikely that the circuit is channelized.

Plese post "show controllers T3". to get the circuit up you must know the correct framing, dsu mode and dsu bandwitdh values. If do not have these, ask telco.

New Member

Subrate DS3 configuration on a 2951 using an NM-T3/E3

Hi Paolo.

Thanks for the quick response.

I do not have access to the router at this time but I can tell you that the framinng is set to "c-bit", the dsu mode is set to "dsu mode 0", which is for a digilink mux and finally the dsu bandwidth is set to 10240.

Thanks,

Gus

New Member

Re: Subrate DS3 configuration on a 2951 using an NM-T3/E3

Hi Paolo,

I just learned from the Telco that the circuit is using M13 framing. Would you know how to configure the NM-T3/E3 for M13 framing?

Thanks,

Gus

Cisco Employee

Re: Subrate DS3 configuration on a 2951 using an NM-T3/E3

Hello ,

you can try following configuration:-

controller T3 1/0

clock source line

framing m23

I hope framing is m23 instead of m13.

Please refer to this document:-

http://www.cisco.com/en/US/docs/ios/interface/configuration/guide/ir_clear_channel.html#wp1052529

Ashish Arora

1301
Views
0
Helpful
4
Replies