I have a 2811 router with a subrate T3/E3 installed in it. When I run a "sh hardware" it shows the card is present, yet a "sh int" does not appear to show it, not can I appear to configure it in any way. The IOS installed should support T3 cards from the research that I did. Is there something special I need to do to be able to configure the card?
I am glad that my suggestion helped you to resolve your problem. Thank you for posting back to the forum indicating that you have solved the problem (and thanks for the rating). It makes the forum more useful when people can read about a problem and can know that they will read a response which did lead to solving the problem.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...