Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Silver

Summary-address Vs Interarea Route

I have a added a static route of /32 pool and redistributing the routes in ospf.

e.g 10.1.1.1/32,10.1.1.2/32 and so on.

After that I afvertise the 10.1.1.0/24 pool in ospf.

On remote end I am getting /32 routes as E2 route and one route as O(10.1.1.0/24). There after advertising the 10.1.1.0/24 with summary-address command. On remote PE I am getting one E2 as /24 route. Now my question is where that /24 route gone which I advertise with the help of network.

regards

shivlu jain

1 REPLY
Hall of Fame Super Silver

Re: Summary-address Vs Interarea Route

Hello Shivlu,

how you managed to get an O or O IA for 10.1.1.0/24 before ?

now you should have only the O or O IA 10.1.1.10/24 installed in the routing table.

the O E2 should just be there to block the /32.

Actually, what you see is strange but it can derive from how you did the first advertisement.

the following may apply to your case

http://www.cisco.com/en/US/docs/ios/iproute/command/reference/irp_osp1.html#wp1013010

discard route command

Hope to help

Giuseppe

174
Views
0
Helpful
1
Replies