Support for Policy-Based routing on HWIC-4ESW card?
I have the following config::
! interface Vlan 10 ip address 10.45.61.129 255.255.255.240 ip virtual-reassembly in ip tcp adjust-mss 1380 ip policy route-map 10-Net ! route-map 10-Net permit 10 match ip address 107 set ip next-hop 192.168.112.126 192.168.112.122 !
access-list 107 deny ip 10.45.61.128 0.0.0.15 host 192.168.1.2 access-list 107 permit ip 10.45.61.128 0.0.0.15 any
Interface FastEthernet 0/0/0
switchport access vlan 10
In theory, everything sould route via the policy with the exception of traffic to the 192.168.1.2 host. Yet, the policy route is never used. IOS 15.1.2(T1).
Given that the syntax is accepted, it seems like this should work, but it does not. Any help for this issue?
Re: Support for Policy-Based routing on HWIC-4ESW card?
On 1841 series routers, the PBR is performed by the IOS. The HWIC-4ESW is not responsible for the PBR.
I have just verified a simple PBR configuration on my 1841 with the HWIC-4ESW card (IOS 12.4(25d) Advanced IP Services) using the VLAN 2, and it seems to be working just fine. Let's double check your configuration first. If that does not turn out to solve the issue then perhaps there is a bug in your IOS - you are running quite a bleeding-edge version and I would be somewhat reserved about it.
To verify your configuration please have a look at the following:
What does the show route-map 10-Net say about the count of policy-routed packets?
Does the show access-list 107 show any hits on individual entries?
Is the IP address 192.168.112.126 and 192.168.112.122 reachable? Is it a directly-reachable address (on a directly connected interface)?
What does the traceroute/tracert performed from a PC in the VLAN10 say?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.