Support of 2Mbps leased line on WIC-2T card on 2811 Router
We are trying to terminate 2 Mbps leased line on WIC-2T port of 2811 router, but the line protocol shows down. Whereas leased lines of slower speed are working fine on same router and same WIC-2T card.
We shfted the line to 2620 router and it worked fine.
We tried to use other 2811 router and WIC-2T cards but the end result was same. Can anybody tell whether 2Mbps line is supported on 2811 router or there is some other issue?
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...