Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

support T1/E1

Hi

which model of CISCO catalyst switches

support T1/E1 port?

4 REPLIES
New Member

Re: support T1/E1

Hi,

Only Cat 6500 supports T1/E1 interface.

http://www.cisco.com/en/US/products/hw/switches/ps708/products_relevant_interfaces_and_modules.html#wan

Please rate if the info was usefull.

Thanks

Deepinder Singh Babbar

New Member

Re: support T1/E1

is there any convertor or other thing

less expensive to support E1 for cat switches?

thank you.

New Member

Re: support T1/E1

There nothing that can be considered low cost for supporting E1/T1 on 6500. This is the only module supporting T1/E1. Though for voice E1/T1 there are other modules which are also very expensive like "Communication Media Module WS-SVC-CMM ", "WS-X6608-E1" & "WS-X6608-T1".

Hall of Fame Super Gold

Re: support T1/E1

Hello,

You should use a router for E1 circuits, not a switch. Current production, the smaller would be a 1841, older models, a 1720. In both cases, you need a WVIC-MFT-1E1

These are very cheap when bought used.

Hope this helps, please rate post if it does!

124
Views
6
Helpful
4
Replies