Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

swapping from active to slave RSP on Cisco 7507

Hi everybody,

I have a Cisco 7507 chassis with two RSP4+ processors running 12.3(18) image. Is it possible to swap active/slave processor issuing a CLI command? Otherwise how can I force this swap?

Regards

Stefano

2 REPLIES
Bronze

Re: swapping from active to slave RSP on Cisco 7507

Hi,

To switch control of a router from the active to the standby Route Switch Processor (RSP), use the redundancy force-switchover command in privileged EXEC mode.

redundancy force-switchover

Regards

Bjornarsb

Re: swapping from active to slave RSP on Cisco 7507

Hi,

Router# redundancy force-switchover

Forces a switchover to the standby RSP.

NOTE: Both the active and standby RSPs must have a high availability Cisco IOS image installed and must be configured for RPR redundancy mode before the redundancy force-switchover command can be used.

HTH, please rate if it does help,

Mohammed Mahmoud.

272
Views
0
Helpful
2
Replies
CreatePlease to create content