Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Switch Command doesn't show output.

I type "ip accounting mac-address" in my cisco switch and the commands are there but it does not show any output. Any ideas?

4 REPLIES
Hall of Fame Super Blue

Re: Switch Command doesn't show output.

dclaro@pmchealthsystem.org

I type "ip accounting mac-address" in my cisco switch and the commands are there but it does not show any output. Any ideas?

Daniel

Not clear what output you are expecting to see. "ip accounting mac-address" enables mac-address accounting on the switch. If you want to see the result of enabling this command use the "sh interface mac" global command.

Jon

New Member

Re: Switch Command doesn't show output.

I meant I type "Show IP Accounting".

I guess the command on a switch would be "Show interface mac-accounting" but that displays nothing. How do you enable accounting on a switch?

New Member

Re: Switch Command doesn't show output.

Anyone?

VIP Super Bronze

Re: Switch Command doesn't show output.

Hello Daniel,

Here is document explaining accounting and how to enable it.

http://www.cisco.com/en/US/docs/ios/11_3/security/configuration/guide/scacct.html#wp3668

HTH

Reza

398
Views
10
Helpful
4
Replies