JEDFOBCF0SW01 uptime is 2 weeks, 2 days, 13 hours, 32 minutes Uptime for this control processor is 2 weeks, 2 days, 13 hours, 32 minutes System returned to ROM by power-on System image file is "bootflash:cat4500-entservicesk9-mz.122-40.SG.bin"
This product contains cryptographic features and is subject to United States and local country laws governing import, export, transfer and use. Delivery of Cisco cryptographic products does not imply third-party authority to import, export, distribute or use encryption. Importers, exporters, distributors and users are responsible for compliance with U.S. and local country laws. By using this product you agree to comply with applicable laws and regulations. If you are unable to comply with U.S. and local laws, return this product immediately.
If you require further assistance please contact us by sending email to firstname.lastname@example.org.
cisco WS-C4507R-E (MPC8245) processor (revision 14) with 524288K bytes of memory . Processor board ID FOX1217G8TA MPC8245 CPU at 333Mhz, Supervisor IV Last reset from PowerUp 18 Virtual Ethernet interfaces 22 Gigabit Ethernet interfaces 403K bytes of non-volatile configuration memory.
Thanks a lot for your reply. There was a lose of power just before the problem. Also since the switch is connected to raw power, this happens often. Kindly tell me whether this will create a problem. This is first time i faces this problem. No one has access of this switch other than me and hence no one could have erased.
Kindly share me any doc or bug id which can cause configuration erase because of power problem
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...