I have an cisco switch (1900 series) with ios version 8.4. i want to configure any one port of switch as access port. but as i enter in interface i am not able to get switchport mode command. i am getting switching option like store & forward , and segment free option. now what to do.
i would say that you need to do a big jump back to how the networks were built 10+ years ago... By the way the 1900 series was really brilliant!!! i'd suggest to use the menu to configure the switch because as far as i remember it was more complete than the CLI.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...