Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Bronze

switch port in access mode, dscp-cos mapping

Hi everybody!

I have a question.

Scenario:

sw1's f0/1 configured with following:

mls qos trust dscp

When f0/1 is in access mode:

When a switch receives the frame , Would switch drive the cos value from DScp-cos map even though the port is in access mode and place the frame in respective queue at ingress port?

thanks a lot!

1 REPLY
Hall of Fame Super Blue

Re: switch port in access mode, dscp-cos mapping

Sarah

The Cos value is derived from the DSCP-Cos map for egress traffic not ingress traffic. This map is needed because the switch always uses an internal DSCP value for all packets.

Using a 3560 switch as an example, you decide which marking, DSCP or CoS, will be used to place the packets into the ingress queues.

So the switch derives the CoS value or the DSCP value from the incoming packet and then maps this to the relevant queue.

Jon

126
Views
0
Helpful
1
Replies
CreatePlease to create content