04-22-2012 10:39 PM - edited 03-04-2019 04:07 PM
Dear all,
If switch is configured as trunk port and connect to hub (simple hub) , is it work?
04-22-2012 10:50 PM
If you connect workstations on the hub and connect the hub on the switch while configuring switchport as trunk then possibly on the switch you would get the logg message of "cdp native vlan mismatch" and the traffic generated from the workstations on the hub would be switched in vlan 1 on the switch by default. This would happen if you have a dot1q trunk. Connecting a hub on trunk port is not a good practice.
Regards,
Talha
04-22-2012 10:54 PM
yes it will work. i already tested it. the switch will consider the hub as a cable .
04-22-2012 10:54 PM
Duplicate post.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: