2950 is a layer 2 only capable switch, not much you can except make sure that the CM port is in the same vlan as the IP Phone. Better yet, do not configure anything and jsut plug them in. By defualt all the ports belongs to vlan 1. If you decide to put the ip phone in the separate vlan than the CM, it will NOT work at all without a router.
also, you might want to consolidate your posts to the same question asked in lan switching forum.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.