Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Switching

Hi,

Iam in a process of shifting the Links from Riverstone switch to cisco 6509.

When i was shifting the Links, one link was not comming up.

Here it is.

I have configured in Fa4/1 as

interface FastEthernet4/1

load-interval 60

shutdown

switchport

switchport access vlan 437

switchport mode access

spanning-tree portfast

end

I have configured the L2 Vlan

I have configured the L3 virtual Vlan as follows

interface Vlan437

ip address 1.1.1.5 255.255.255.0

load-interval 60

shutdown

end

when it is in shutdown mode when i give the command

sh vlan

It shows

437 XXXX active Fa4/1

But when i shift the Link and make unshut in both the interfaces.

the Link comes up

but

when i give Show Vlan

It shows like this

437 XXXX active

Can any one Help me out how this happnes.

thanks

Ranga

1 REPLY
Hall of Fame Super Bronze

Re: Switching

Please post the output from typing

sh int fa4/1

sh int status

after typing the unshut command.

Also, do you see fa4/1 being allocated to another VLAN ? (VLAN 1)

108
Views
0
Helpful
1
Replies