Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SWO - Active to Standby then reboot back to Active RSP

Dear Friends,

We have faced an Switchover in our 7606 router for unknown reason.

SWO to standby than reboot back to active one.

Based on crash file:

Aug  1 21:45:13 UTC: %PFREDUN-SP-STDBY-6-ACTIVE: Initializing as ACTIVE processor

Aug  1 21:45:13 UTC: %FABRIC-SP-STDBY-5-FABRIC_MODULE_ACTIVE: The Switch Fabric Module in slot 5 became active.

Aug  1 21:45:14 UTC: %SYS-SP-STDBY-3-LOGGER_FLUSHED: System was paused for 00:00:00 to ensure console debugging output.

Aug  1 21:45:14 UTC: %OIR-SP-3-PWRCYCLE: Card in module 6, is being power-cycled (Switchover)

Aug  1 21:46:48 UTC: %PFREDUN-SP-6-ACTIVE: Standby initializing for SSO mode

Aug  1 21:46:49 UTC: %SYS-SP-3-LOGGER_FLUSHED: System was paused for 00:00:00 to ensure console debugging output.

Aug  1 21:46:52 UTC: %PFINIT-SP-5-CONFIG_SYNC: Sync'ing the startup configuration to the standby Router.

Aug  1 21:47:15 UTC: %FABRIC-SP-5-CLEAR_BLOCK: Clear block option is off for the fabric in slot 6.

Aug  1 21:47:15 UTC: %FABRIC-SP-5-FABRIC_MODULE_BACKUP: The Switch Fabric Module in slot 6 became standby

Aug  1 21:47:16 UTC: %DIAG-SP-6-RUN_MINIMUM: Module 6: Running Minimal Diagnostics...

Aug  1 21:47:20 UTC: %DIAG-SP-6-DIAG_OK: Module 6: Passed Online Diagnostics

Aug  1 21:47:20 UTC: %OIR-SP-6-INSCARD: Card inserted in slot 6, interfaces are now online

Aug  1 18:47:27.333: SP: SP detected RP/Draco rebooting, resetting SP

DHKC-R76-01#sh module

Mod Ports Card Type                              Model              Serial No.

--- ----- -------------------------------------- ------------------ -----------

  1   24  CEF720 24 port 1000mb SFP              WS-X6724-SFP       JAF1205BFJM

  2    0  4-subslot SPA Interface Processor-200  7600-SIP-200       JAE12088TA8

  5    2  Route Switch Processor 720 (Active)    RSP720-3C-GE       JAE12088VUP

  6    2  Route Switch Processor 720 (Hot)       RSP720-3C-GE       SAL1551Z508

DHKC-R76-01#sh redundancy states

       my state = 13 -ACTIVE

     peer state = 8  -STANDBY HOT

           Mode = Duplex

           Unit = Primary

        Unit ID = 5

Redundancy Mode (Operational) = sso

Redundancy Mode (Configured)  = sso

Redundancy State              = sso

Your help is appreciated.

Regards,

Ahmed

483
Views
0
Helpful
0
Replies
CreatePlease login to create content