Would it say Config_"I" or config T if it were a console login?
We just had a 7600 relaod and I got the Config_I message and no one was consoled in at the time. I was just checking to make SURE the "Config_I" notifications was just informational saying it restarted and loaded from the start config.
%SYS-5-CONFIG_I: Configured from memory by console
Especially if your 7600 did a reload then it is quite certain that this is just an informational message. I think that perhaps you are confusing what is in a syslog message telling where the message came from (Config_I) with the command you use to enter configuration mode (conf t).
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.