Mar 5 22:06:51 192.168.76.1 51: router: Mar 6 03:05:00.725: %SYS-5-CONFIG_I: Configured from console by pamirian on vty0 (192.168.76.2)
the first date is the (unix/syslog) date that is correct. the second (03:05:00.725) is the one given by my cisco router. I don't understand why I have (03:05:00.725) when the show clock comment tells me 22:06:51.613 EDT Sun Mar 5 2006....
I dont know if this will help but here is what I managed to find:
Some platforms have a hardware clock that is separate from the software clock. In Cisco IOS software syntax, the hardware clock is called the "calendar." The hardware clock is a battery-powered chip that runs continuously, even if the router is powered off or rebooted. After you set the hardware clock, the software clock will be automatically set from the hardware clock when the system is restarted or when the clock read-calendar EXEC command is issued. The time specified in this command is relative to the configured time zone.
The following example manually sets the hardware clock to 1:32 p.m. on May 19, 2003:
I believe that the answer is fairly simple. The router knows the correct time but defaults to reporting syslog using UTC. The solution is to use the sevice timestamps log command to get syslog to use the local time instead of UTC.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...