Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

Syslog missing # packets

I seem to be missing some settings.

I need ALL syslog messages generated by two border routers but cannot get passed the missed packet status messages:

access-list logging rate-limited or missed 23 packets

I do receive most mesages but periodiucally receive the rate-limited or missed # packet mesage.

These two routers are consistently running at 2% utuilization, NEVER higher than 3%. I never receive more than 50 mesages per second

This is the config related to the logging on each of the 2 routers:

logging userinfo
logging queue-limit trap 200
logging buffered 32768
logging rate-limit 10000
logging history size 500
logging origin-id hostname
logging facility local6
logging 10.2.5.247
logging 10.4.26.85

I tried turing off the logging rate-limit 10000 command with the no logging rate-limit but this did not help either.

Router is a Cisco 2821 running c2800nm-advipservicesk9-mz.124-15.T9.bin IOS.

Thank you for ANY assistance!

Frank

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Syslog missing # packets

Hi

Please refer the below link.

https://supportforums.cisco.com/thread/2011609?decorator=print&displayFullThread=true

The below link will help to userstand access control list logging .

http://www.cisco.com/web/about/security/intelligence/acl-logging.html

Regards

Chetan Kumar

1 REPLY

Re: Syslog missing # packets

Hi

Please refer the below link.

https://supportforums.cisco.com/thread/2011609?decorator=print&displayFullThread=true

The below link will help to userstand access control list logging .

http://www.cisco.com/web/about/security/intelligence/acl-logging.html

Regards

Chetan Kumar

222
Views
0
Helpful
1
Replies