I have a serial interface card (s0/1/0.16) which we curretly use for our T-1 connection. I have second T-1 line coming and was wondering if I could use the "controller T1 0/2/0' interface for the same purpose as the serial interface? (see config below)
controller T1 0/2/0 shutdown framing esf linecode b8zs ! controller T1 0/2/1 framing esf linecode b8zs ! ip ssh authentication-retries 2 ! !!! ! interface Serial0/1/0 no ip address encapsulation frame-relay no ip route-cache cef frame-relay lmi-type ansi ! interface Serial0/1/0.16 point-to-point ip address XXXXXX
no ip redirects no ip unreachables no ip proxy-arp snmp trap link-status frame-relay interface-dlci 16 IETF
The reason we are getting an additional T-1 line is to seperate our public from our staff traffic. So, the original T-1 will have traffic will have it's own subnet of 192.168.69.0/25 and the additioanl T-1 will have a subnet of 192.168.129/25.
I have attached the config of both routers and a diagram. Please let me know if you need any other info.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.