T1 controller up, Serial up, line protocol down - Need help please
This is a problem that has been bugging me for quite some time and I can't get it solved. I have 2 locations with a T1 line beetween them. The carrier comfirmed the line is fine, full T1 line with ESF framing and B8ZS linecode.
Location A has a 2-port channelized T1 module, a NM-2CT1-CSU in a 2611XM (IOS 12.3(10)). One port is already used for another connection. Location B has a WIC-1DSU-T1 (Cisco 1-Port T1/Fractional T1 DSU/CSU WAN Interface) in a 2610XM (I dont know the IOS, this is the remote router and I have no direct access).
My question would be: do I have the right modules installed for this ? I mean, Location A has a channelized T1 card and Location B has a T1/fractional T1. Is this enough ? If not, what would I need in Location B ?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.