Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

T1 DSU/CSU compatible

Does anyone know if the T1 DSU/CSU card is compatible with a VWIC-2MFT-T1? We are going to use it as a data t1.

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: T1 DSU/CSU compatible

Yes.  I've tested this in my lab but with a homemade t1 xover.

Are these devices going to be at the same location? I'm just curiuos as to what excatly your doing, that's all - don't mean to poke..

6 REPLIES
Hall of Fame Super Gold

Re: T1 DSU/CSU compatible

Please state the exact part number and on which router model you intend to use it.

New Member

Re: T1 DSU/CSU compatible

The new card is a WIC-1DSU-T1-V2. The WIC-1DSU-T1-V2 will be in an 1841 and the VWIC-2MFT-T1 is already in a 2821. Can these two cards interface with each other? Standard RJ48 T1 cable?

New Member

Re: T1 DSU/CSU compatible

Yes.  I've tested this in my lab but with a homemade t1 xover.

Are these devices going to be at the same location? I'm just curiuos as to what excatly your doing, that's all - don't mean to poke..

New Member

Re: T1 DSU/CSU compatible

data point to point t1 in seperate physcial locations.....slow i know.

New Member

Re: T1 DSU/CSU compatible

That all depends on the bandwidth and the amount of traffic going across. If you need help or configs to set this up let me know.

Good Luck..

New Member

Re: T1 DSU/CSU compatible

I have a few other P2P T1s configured but just not with this particular card. thanks for the help.

685
Views
0
Helpful
6
Replies