I have 2 T1's that are configured between 2 offices and would like to have this configured in a failover when the primary line drops. My primary T1 is a Microwave cicuit with line of site and my second T1 is a traditional circuit. Since the Microwave circuit does go up and down when the weather is bad i need to setup some kind of delay before failing over to the other circuit. Ideally i would like to have the failover wait for 2-3 minutes when the microwave circuit drops before failing over to my other T1. Will using routes with a higher metric perform this objective or do i need to be using someting like QoS to accomplish this task?
Did you try backup interface command and backup delay command to make sure that your secondary comes active once the primary fluctuates for the limited period of time mentioned in the backup delay command ?
I have not tried using the backup delay but will give that a try. I will have both T1's active at all times but traffic is segemented on which T1 is being used. In other words my users will use the Microwave circuit when accessing the other office which does include my voice traffic a well. My SAP traffic will use T1 circuit 2 at all times as the default. In the event that either one of the T1's fail i would want the traffic to be sent over the other T1. The microwave does flutter so goes up and down for short time periods. This is why i would only want to have a delay on the microwave circuit.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.