thanks for the info. We are trying to find increased bandwidth at our remote sites here in AK. The T1 lands back at our central office 7206. So, were looking at per packet simply because all traffic will come back to the main campus. However, I'm hearing that may cause problems with our H.323 video due to packet sequencing (UDP) issues. But that might not be a big problem since we prioritize packets prior to reaching the router.
First you want to make sure that you do have both routes to the destination in the routing table. Once that is verified you can use CEF to do per-packet load balancing.
Rack1R1#sho run | in (cef|FastEthernet0/0|per-packet)
ip load-sharing per-packet
If you do run into problems with the video traffic you may need to disable per-packet load balancing but that may not be an issue if both connections between the routers are directly connected (no other routers between them).
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.