Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

T1 Router Configuration Question

I have a T1 line that connects to a seperate CSU/DSU that is managed by the service provider.

I manage the router. What configuration do I need to put on the serial interface of the router to get the T1 going. Do I just have to put an IP address on the Serial interface that connects to the ISPs CSU/DSU or do I have to put all those extra controller commands, such as the line code etc. ?

Thank You for any reponses

1 REPLY

Re: T1 Router Configuration Question

You would configure just the IP address on your router Serial interface and the encapsulation type. Default encap on Cisco Serial interface is HDLC. In addition, add a static default route to point to your ISP.

Pls. rate all helpful posts.

HTH,

Sundar

84
Views
5
Helpful
1
Replies