Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

T3 Configuration Verification.

My customer told me that T3 line has many CRC error during day.So I checked my configuration,

the config like below:

card type t3 1

!

controller T3 1/0

cablelength 10

!

interface Serial1/0

description From Seoul To Chung do

bandwidth 44210

ip address 10.40.250.1 255.255.255.0

dsu bandwidth 44210

!

In Controller T3,the cablelength related the CRC error? When I miss configuration length?

and dsu bandwidth 44210 configure in just one side? or not both configured?

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: T3 Configuration Verification.

Under your controller T3 1/0 type in the command "clock source line". This should eliminate those CRC errors.

Regards

2 REPLIES

Re: T3 Configuration Verification.

Hi,

To configure the "Card Type and Controller" for T3 you need to follow the following "SUMMARY STEPS"

1. enable

2. configure terminal

3. card type t3

4. controller t3

5. framing

6. cablelength

7. clock source

8. exit

NEXT

To configure DSU Mode and Bandwidth for T3 ou need to follow the following "SUMMARY STEPS"

1. enable

2. configure terminal

3. interface serial

4. dsu mode

5. dsu bandwidth

6. exit

are you covered all? Thanks Goutam (Pls rate if I am informative)

New Member

Re: T3 Configuration Verification.

Under your controller T3 1/0 type in the command "clock source line". This should eliminate those CRC errors.

Regards

316
Views
0
Helpful
2
Replies
CreatePlease to create content