We are having issue with one of our T3 controllers, we have tried everything but line protocol is not coming up.
Controller is showing up at sides but line protocol is in down state.
One side we have ASR1K and other side it's 7600 series router.
Below are the actions performed by us so far:
1- we have done loop testing with both side of carrier, found clean loop without errors. 2- Carrier has confirmed following setting at their side. Encap Type : ppp-auto Framing : c-bit Admin MTU : 2000 Oper MTU : 2000 3-We have replaced the cable at both side. 4-We have done SPA reset at both side. 5-we have changed Framing from C-bit to M13,M23 at both side but no diffrence . 6-we have changed clocking from Line to internal at both side but No difference. 7-Frame-relay intf-type changed to DCE and DTE at both side but no diffrence. 8-We have done port movement on the same SPA card at both end 9-we have done SIP reload at both end
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...