I have a Cisco router connected to a Juniper via T3, and there are periodic bursts of 100's of rx errors on the Cisco side. The salient feature is the CRCs and overruns increase in lockstep but other error counters are 0. The controller always shows clean, extended BERT testing shows clean and CPU is about 3%. Clock is set internal on the Juniper side and line on the Cisco side. I am stumped, anyone got an idea?
show int s1/0
Last clearing of "show interface" counters 01:08:28
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
30 second input rate 5354000 bits/sec, 1027 packets/sec
30 second output rate 46000 bits/sec, 108 packets/sec
8418145 packets input, 4470176042 bytes, 0 no buffer
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...