we have tried to configure AAA on WAAS (Wide Area Application Services)device. we have applied all the aaa commands on waas device and made necessary configs changes on tacacs server as well.
WAAS device is speaking to tacacs server and I am able to login to waas device through tacacs id, the problem here is when i tried to go to enable mode on waas device its not accepting my tacacs password instead its taking local password.
I am sure i am missing something here, can any one throw some lights here to solve this issue as this is very ciritcal activity for me.
Many thanks in advance and pasted AAA configs applied on WAAS device.
Pretty clearly the problem is that it is requiring the local enable password because there is no configuration in aaa for authenticating enable. So we need to find the correct syntax to use. Can you post the output that you get from online help?
- go into config mode.
- type aaa authentication enable ?
- if it shows default as an option then type
aaa authentication enable default ?
Perhaps this will help us figure what syntax it is looking for.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...