Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

TCL and EEM

Hi

I use either TCL or EEM to remotely configure the interfaces. In Most cases TCL works and fails in some routers while executing. only difference I have noticed is IOS which is weired.

EEM supports all routers but The EEM works in very few routers and does not execute in most routers.

1) why TCL fails

2) same EEM Scripts does not executes on some but not on most

3) Is there any way I can configure the  cisco routers remotely

Many Thanks 

  • WAN Routing and Switching
Everyone's tags (2)
116
Views
0
Helpful
0
Replies
This widget could not be displayed.