I am a teleworker. At my home I have ADSL connection with Modem, Cisco 871 security bundle router (1 wan, 4 lan). I want to configure Site to Site IPSEC for accessing Corporate data from my pc only on utp. And want other users at my home to access internet simultaneously on utp. I only have one subnet on LAN /24. Should i break subnet and connect adsl lan port to router wan port. Configure IPSEC for /25 and other / 25 access internet. Look forward for revert with router configuration. And a low level design. Thanks for the support.
Thanks I am the administrator. Can you provide sample configuration of remote cpe (871) & Central Router (6500 switch). I will do necessary conf at remote cpe and ask for conf at 6500. As i am a new bie and understand little configuration.
Thanks for the Input. I will ask my IT staff for conf at ASA / Router. As i am home user i will not be able to hire anybody. request if you could share the cpe (871) and ASA configuration i will try and implement. The home configuration is as follow:
1. LAN IP's :192.168.1.0 /24
2. WAN IP Public: Dynamic Single IP.
3. Corporate Static WAN IP.
User's on Internet from my home get same ip and simultaneous session. I believe ISP has applied PAT at the gateway. Request you again if you could share configuration for accessing Internet direct from Home DSL & IPSEC Site to site VPN from CPE Router (871 security Bundle).
I would think long and hard before using a hardware VPN client. Not that i'm against it, i use one (871) myself. With all due respect if you are not experienced enough to configure / setup this up then you're not in a position to understand the risks of doing so.
Any company that has a clue has a policy against hardware vpn clients. If they do allow it it's typically pre-configured / plug-n-play device that sits on your LAN and tunnels through the ISP's modem.
I'm working on a project that includes basic router configurations. I configurated everything including: line console 0, line vty 0 15 and secret passwords. There are 3 routers in the network and every LAN is going t...
Desire to create Terminal Server ("TS" in this document) out of 2811 Cisco Router with HWIC-16A card (with Octal cables)
Desire to use SSH over Telnet
TS is ip'ed, SSH access configured (to the TS)
Python based Script to BULK Import/Delete devices using Cisco Prime API
Check my Repo on GitHub for all the details ( see below link )