You provide an incomplete description of configuring the router. I do not see any default route in what you posted. It is not clear whether it is configured and just not shown or if it is not configured.
You do not tell us whether the router is connected and working. Can you clarify whether the router has connectivity to the Internet? Does a PC connected on the inside interface access Internet resources ok? Can the router ping addresses in the Internet. Can you ping the router from the address that you are attempting telnet from?
You raise the issue of the access list to use with NAT. I had noted the permit ip any any as an issue, especially for PCs connected on the inside. But since the question is about telnet to the router from outside, will the packets be directly to and from the router and will they not be using the outside (public) address? In which case I am not sure that address translation is the issue.
I do agree that your suggested change is good. But I am not sure that it addresses the original question.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.