Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

telnet issue

hi everyone,

please i have an issue with my routers,from R2 i can telnet to R1 int serial 0/3/0:0 ip address,but i cannot telnet fron R1 to R2 int serial0/3/0:0 ip address.please what could be wrong attached are the configs.

2 REPLIES
Community Member

Re: telnet issue

ACL 23 on R2 doesn't permit the telnet session. The ACL is not defined on R1, which is the reason it works there.

Community Member

Re: telnet issue

1. Create an ACL on R2 router and permit Telnet for source R1.

2. At the last line of ACL, user Log words like

deny ip any any log

3. Try if it will not work, then run debug on the interface S0/3/0:0 on router 2.

89
Views
0
Helpful
2
Replies
CreatePlease to create content