Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Telnet of ASA firewall

hi all,

After I added below command in ASA, the telnet session seeems success but there is just a cursor prompt without other configure i can see. any command i missed ?

interface Management 0/0

nameif management

telnet 192.168.1.0 255.255.255.0 telnet

5 REPLIES

Re: Telnet of ASA firewall

Hi there,

The syntax for the command you are trying to use is as follows;

telnet

So for example, you have named your Management0/0 interface 'management' so the correct syntax you should use is

telnet 192.168.1.0 255.255.255.0 management

You currently have it assigned to an interface named 'telnet'.

Nik

New Member

Re: Telnet of ASA firewall

Sorry, a typing mistake.

Currently, I have set "telnet 192.168.1.0 255.255.255.0 management".

When I telnet the ASA, a black prompt open but no words appear

Re: Telnet of ASA firewall

Have you configured an IP address for the management interface? This needs to be part of a subnet and cannot be a /32.

New Member

Re: Telnet of ASA firewall

Yes, already configured

int management 0/0

ip address 192.168.1.1 255.255.255.0

New Member

Re: Telnet of ASA firewall

Dear Acbenny,

I met this problemed before, pleaes try to change other computer and one more your connection is slow.

Best Regards,

Join

272
Views
0
Helpful
5
Replies