Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Telnet using source IP address

Dear Experts,

Is there any way I can TELNET using the source IP address. I am aware of the

command

"telnet 192.168.1.1 /source-interface fastethernet 0"

But Here in this command I am able to specify only the Interface and not the

IP Address. Why i raised this point is, I am trying to TELNET a remote host

using my secondary IP address of the Interface.

Thanks in advance

sairam

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Telnet using source IP address

hi mate,

It is possible , try this command :)

telnet 10.10.10.1 /source-interface fastEthernet 0/1 /route:(Ip )

Cheers

Som

5 REPLIES
Hall of Fame Super Silver

Re: Telnet using source IP address

sairam

I am not aware of any way in IOS to telnet and to source the telnet packets from a secondary address. When an IOS router generates a packet (including generating a telnet packet) the default is to use the primary address as the source and I am not aware of any way to change this behavior.

HTH

Rick

New Member

Re: Telnet using source IP address

Hi Rick,

Thanks. recently i surfed a Blog site and got the workaround for source telnet. But he didnt said how to do.He has shown only the solution. Please refer the link below

http://blog.zakir.net/index.php?/archives/44-Router-Tricks-Sourcing-telnet-from-secondary-IP-address.html

Hope it will give some clues. Please suggest how it works

sairam

New Member

Re: Telnet using source IP address

Hi,

Had anybody seen the link. can you please shed some light on this

sairam

New Member

Re: Telnet using source IP address

hi mate,

It is possible , try this command :)

telnet 10.10.10.1 /source-interface fastEthernet 0/1 /route:(Ip )

Cheers

Som

New Member

Re: Telnet using source IP address

Hi,

Have you gone thru the link. I am not able to understand or interpret the way he made the ACL to do Source TELNET

Thanks in advance

sairam

22093
Views
0
Helpful
5
Replies