Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Terminating PBX E1 line on NMCE1T1-PRI module port

Hi everybody. I have small doubt. Is it possible to terminate PBX on Channelized E1T1-PRI module port and will the module support Voice ?

Thanks in Advance.

4 REPLIES
Silver

Re: Terminating PBX E1 line on NMCE1T1-PRI module port

Hi,

Yes you can. What is the correct type of the module, because if you want that the calls to be sent through voip then you have to have DSP's on it.

Hope it helps,

Krisztian

Community Member

Re: Terminating PBX E1 line on NMCE1T1-PRI module port

Hi Krisztian,

I have NM-2CE1T1-PRI module.

will the module support Voice ?

can I coonect PBX to this module E1 port ?

How would be the configuration ?

I am using 3845 router and vae DSPs on it.

awaiting for ur reply

Thanks in Advance

AlluReddy

Silver

Re: Terminating PBX E1 line on NMCE1T1-PRI module port

I think the NM-2CE1T1 can be used only for WAN connection or for modem termination (using appropriate DSP). If you want to use voice then you need to have HDV module.

Anyway the PBX can be connected to the PRI port.

Community Member

Re: Terminating PBX E1 line on NMCE1T1-PRI module port

Thanks for ur Reply.

So this module does not support voice. And I want to terminate PBX on E1 for voice only.

Thanks for ur Information.

185
Views
0
Helpful
4
Replies
CreatePlease to create content