We are having Channelised E1 ports on 3845 routers. We have created channel groups from 1 to 30 and corresponding serial links ( Created automatically ). But somw how the controller is not coming up. We have earlier tried "hard loop" test to test router card. Which was found ok. Now as when we have connected E1 modem to the controller we are not getting the prptocol up. We tried to give local loop towards router from modem, expecting we will see a Looped status for every serial links. But we could not see any loop. Firstly i am not sure about do we really get such looped status on serial link on E1 ports. I am sure that we can see the loop status on point to point link ( serial port ) when a local loop is given towards router from modem. But i would like to know if such loop can be seen on E1 ports by giving local loop by E1 modem.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...